I was confused because the Palo Alto documentation says about the heartbeat backup: “ Uses the management ports on the HA devices to provide a backup path for heartbeat and hello messages. The official Palo Alto Networks links are here: High Availability Resources.) (The screenshots are from a PA-5050 with PAN-OS version 6.1.5 running.
#Pa vm esx 6.1.0 how to#
I was a bit confused while reading the documentation of the high availability instructions since it did not clearly specify when and where to use the dedicated management port for what kind of “backup”.īasically, it should read that there are two different ways on how to use the dedicated management for a HA Backup: the heartbeat backup OR the HA1 backup. Following are the configuration and monitoring screenshots:īeside the HA1 and HA2 interfaces on a Palo Alto Networks firewall, there are the HA1/HA2 Backup and Heartbeat Backup options. The Cisco ASA 5505 is running version 9.2(4). That is: The Quagga router (172.16.1.8) is not shown on any other firewalls/routers. The Quagga router was added to this lab after most of the listings were saved. Beneath each screenshot is a detailed description of the the configuration that is shown.ĭuring the tests, a single Cisco An圜onnect client was connected and therefore redistributed with a /128 IPv6 address prefix. The following devices are in alphabetic order.
![pa vm esx 6.1.0 pa vm esx 6.1.0](http://skieycomics.weebly.com/uploads/1/2/3/9/123915715/371636426.png)
I am showing my lab network diagram and the configuration commands/screenshots for all devices. Similar to my test lab for OSPFv2, I am testing OSPFv3 for IPv6 with the following devices: Cisco ASA, Cisco Router, Fortinet FortiGate, Juniper SSG, Palo Alto, and Quagga Router.
#Pa vm esx 6.1.0 password#
opt/unetlab/wrappers/unl_wrapper -a fixpermissionsĭefault username is admin with password admin.
![pa vm esx 6.1.0 pa vm esx 6.1.0](https://itforvn.com/wp-content/uploads/2017/10/Upload-Firmware-PaloAlto-Eve8.png)
Mv virtioa.qcow2 /opt/unetlab/addons/qemu/paloalto-6.1.0 Then convert the disk to the qcow2 format: /opt/qemu/bin/qemu-img convert -f vmdk -O qcow2 PA-VM-ESX-6.1.0-disk1.vmdk virtioa.qcow2Ĭreate the UNetLab image: mkdir -p /opt/unetlab/addons/qemu/paloalto-6.1.0 Then login as root using SSH protocol and uncompress it: mkdir tmp Upload the downloaded image to the UNetLab master node using for example FileZilla or WinSCP. Remember that UNetLab image names are strongly suggested for lab portability. The following procedure refers to the most recent and supported image only. SUPPORTED PALO ALTO VM-100 IMAGES UNetLab Image Name The Palo Alto firewall is available as a virtual appliance.